Replace the drive if the error repeats. Check cabling and retest. No way. Replace the drive if the error repeats. http://discusswire.com/error-code/dell-error-code-0141-hard-drive.html
SERVO is data on track location. The Identify Drive Command has not received an acceptable response from the drive. Test complete Defect Free 224 Errors not Repaired Errors found and have not been repaired. An interrupt command to perform a specific task failed to complete. https://support.wdc.com/knowledgebase/answer.aspx?ID=11711
Replace the drive if the error repeats. Please re-test the drive with Data Lifeguard. Replace the drive if the error repeats. Replace the drive.
The command set to be executed has timed out. You may need to rescan to ensure that the repairs were effective. Check cabling and retest. Check cabling & retest.
Re-Test Drive 2 SMART Attribute Over Threshold Self-Monitoring, Analysis, and Reporting Technology (SMART) threshold exceeded condition. Check your floppy and retest. Check cabling and retest. https://support.wdc.com/KnowledgeBase/answer.aspx?ID=654 This may be due to a media or read/write error.
to report if a drive has failed, it must be enabled as a system option. Ten or more instances of information on data positioning and location could not be found. This may be an anomaly or a defect with the drive. If the errors continue, replace the drive.
The cable is loose, broken, or not plugged in. https://hardforum.com/threads/wd-diagnostics-error-code-223.1300005/ Check connections and retest. Dell Hard Drive Error Codes Drive should be replaced. Western Digital Error Code 0007 Please contact the system vendor for the above-mentioned information.
Retest the drive with Data Lifeguard. check my blog This error may also appear if the floppy has been infected by a hidden virus. Drive Reliability Monitor. Drive should be replaced. Seatools
Further errors indicate a defective drive. Replace the drive. hlvadgama 2011-08-07 17:06:25 UTC #3 Thank you for the reply. http://discusswire.com/error-code/how-to-fix-error-code-0146-dell-inspiron.html An error was reported by the drive during the Write command (to cause the auto-relocation) or the Read Verify command (to verify the relocation happened).
Re-test Drive 143 RANDOM SEEK ERROR Error encountered during random seek. The automatic repair feature can attempt a repair if possible. Re-test and Repair Option diagnostic utility 212 10+ Uncorr ECC Errors Error Correction Code (ECC) 10+.
Re-test Drive with appropriate diagnostic utility 133 Illegal ID FW overlay not found. Replace the drive if the error repeats. Retest after checking the connections. The drive has failed and must be replaced.
Retest. Re-Test Drive 102 Seek Timeout A Seek command did not complete in the time allotted for its completion. To run in ATA 66 and ATA100 rates, an Ultra ATA 80 -conductor cable must be used. have a peek at these guys Replace the drive if the error repeats.
Replace the drive if the error repeats. Re-Test Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. A number of ECC errors (between 2 through 9) have been detected. I have to give credit where credit is due, the WD diagnostics worked, but here is where I want to spread some wisdom.
The drive has failed and must be replaced. Replace the drive if the error repeats. Check cabling & retest. Re-test Drive 163 Unknown Error Queued command timed out.
Re-Test Drive 7 SMART Offline Immediate Command Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Offline Immediate command failed. Drive should be replaced.